Garage Door Opener Runs And Stops

If your garage door opens and suddenly stops it might be because of your logic board.

Garage door opener runs and stops.

Open up the case and look for a screw type track that moves when the opener runs. Measure the height where the door stops while it is being opened. The motor continues to run after the garage door is closed. When the opener is activated the screw rotates causing the nut to move until it reaches the switch.

These systems usually operate with little difficulty but occasionally. If it happens at all it will usually be noticed when you first install the garage door opener. If this is the case the motor will run but as the chain isn t where it should be it can t generate the lift to open the door. If you find that it keeps running this can present a problem in your system.

Garage door openers use a system of springs sensors pulleys and tracks to automatically open and close your garage door. In a typical situation the motor for your garage door opener should stop running once the door has closed. This requires a simple turn with a screwdriver to reset the limit so the garage door opens and closes all. Garage door opens but the motor won t stop running.

When this unusual problem occurs it means the up limit switch probably needs to be moved away from the motor unit. Doing this can save you some amount of cash. Quite often the cause of your door s malfunction is an improperly set garage door limit. Turn off the sure lock aka vacation mode on the wall console check if limits are properly set check the door balance condition and door spring check opening force control or force settings.

The logic board receives and responds signals to any remote. You might need to consider replacing it if your door is not working properly or you may purchase a new opener. In most cases the cause will be a stripped gear or a chain that has come off the sprocket. Sometimes the limit switch is activated by the movement of a specially shaped nut traveling on this track.