Genie Garage Door Transmitter Not Working

The transmitters remotes will not work to close the garage door.

Genie garage door transmitter not working.

See your owner s manual for more details. Door starts down then stops before it is closed. The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors. The method to reengage the carriage depends on the model of garage door opener you own.

Check that the emergency release cord has not been pulled. However if all the garage door openers stop working at the same time then most likely the garage door antenna is not attached properly or the garage door opener itself needs to be reset. If this is the reason you will need to reengage the carriage. Step 2 press the open button on your remote transmitter three times while inside of your garage and pointed at the motor.

Press and hold the wall console button until the garage door is completey closed. If an operational problem exists and the garage door opener will not close the opener can be forced to close. The most common reason for a garage door remote transmitter to stop working is a dead battery. Check garage door for binding.

Your garage door may be disconnected from the opener. Check for interference from adjacent photo eye sensors of any brand.