Genie Garage Door Will Close But Not Open

Genie garage door opener opening or closing problem fix.

Genie garage door will close but not open.

If you have a dent use a block of wood against it and use a hammer against the wood to hammer that dent out. If the motor is running on your garage door opener but the door itself isn t opening don t panic. The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors. This is the sign of the close limit being set too far and reading the ground as an obstacle.

This triggers a safety measure that causes the door to open again. Turn the close force dial in small increments until the garage door reaches the ground when you hit the close button on the remote. This can happen to a newly installed garage door or an older one. Check that the emergency release cord has not been pulled.

Door starts down then stops before it is closed. You can adjust the close force and limit switch to the correct levels and you should be good to go. Adjust the limit so the door closes until it just touches the ground. Check garage door for binding.

The transmitters remotes will not work to close the garage door. If the sensitivity is set too low or high the door will not open. Contact us for garage door spring repair. Your garage door may be disconnected from the opener.

If this is the reason you will need to reengage the carriage. You will find that the door will only move an inch or so in the close direction and reverse. The method to reengage the carriage depends on the model of garage door opener you own. If the garage door closes hesitates and opens again.

Read the manufacturer s directions to reset the sensitivity. If an operational problem exists and the garage door opener will not close the opener can be forced to close. See your owner s manual for more details. Genie openers apply only limited force to the garage door during closing.

The door won t reach the ground if the maximum level of force is exceeding during closing. Press and hold the wall console button until the garage door is completey closed. If the garage door is not opening but the motor is running the problem might rest on the springs in your garage door assembly.