It was late in the evening.
Genie garage door will not close unless hold button.
Check for interference from adjacent photo eye sensors of any brand.
Garage door does not close.
My garage door will not close unless i hold the button down.
Hold down on the buttons until the in car red light flashes rapidly.
To open my garage door i have to hold down the button on my wall until the door is at least halfway up.
It had worked just fine a few hours earlier.
But seems to be unable to close all the.
My wife had just come home.
I ve made sure there are no obstacles and that the sensors are aligned properly.
Leaving it open all night is not a.
When the door is up the sensor lights are off.
The remote control in my car will not work at all.
Then within 30 seconds hold the button on your remote for three seconds or until garage door opener s lights flash or the led light on your opener blinks.
The garage door did not want to close when she pressed the button on the remote.
Check garage door for binding.
If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down.
It just opens an inch and stops.
Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously.
Eye on both side of the door is not on i have to hold down the bottom in the garage to bring the door down.
Door starts down then stops before it is closed.
Press and hold the wall console button until the garage door is completey closed.
When i push the remote in my vehicle to close the garage door it will close and remain closed for.
To reprogram your garage door remote locate then press your opener s learn button.
My tools are in the garage.
I have a genie intellicode.
The problem starts when you hit the button to close it and the door starts to close.
Try using your remote to open or close your door to determine if the reprogramming was successful.